How to use feed grinder correctly

After purchasing a good feed grinder, if it is not used correctly, it will not only shorten the service life of the feed grinder, but also affect the work efficiency, resulting in half the result with twice the effort.

1. The pulverizer should be fixed on the cement foundation for long-term operation. If the working place is often changed, the pulverizer and the motor should be installed on a base made of angle iron, and an anti-vibration device should be installed. If the pulverizer is powered by diesel, the power of the two should match, that is, the power of the diesel engine is slightly greater than the power of the pulverizer. And make the pulley grooves of the two consistent, and the outer end faces of the pulleys are on the same plane.

2. After the pulverizer is installed, check the fastening condition of the fasteners of each part, and tighten them if they are loose.

3. Check whether the tightness of the belt is appropriate, and whether the motor shaft and the shredder shaft are parallel.

4. Before starting the pulverizer, first turn the rotor by hand to check whether the claws, hammers and rotor are flexible and reliable, whether there is any collision in the shell, whether the rotation direction of the rotor is consistent with the direction indicated by the arrow on the machine, whether the motor and the powder Whether the lubrication of the pure machine is good.

5. Do not replace the pulley casually, in case the crushing chamber explodes due to high speed, or the work efficiency is affected by too low speed.

6. After the crushing table is started, it will idle for 2-3 minutes first, and then feed the material after there is no abnormal phenomenon.

7. Pay attention to the operation of the pulverizer at any time during work, and feed materials evenly to prevent clogging and stuffy cars, and do not run overloaded for a long time. If vibration, noise, overheating of the bearing and body, or material spraying are found, stop the machine immediately for inspection, and continue working after troubleshooting.

8. Clean up the iron removal device in time to prevent copper, iron, etc. from entering the crushing chamber and causing accidents.